:: AForge.NET Framework :: Articles :: Forums ::

Electronic component detection

The forum is to discuss topics related to different areas of image processing and computer vision.

Electronic component detection

Postby bri999 » Mon Oct 14, 2013 10:44 pm

I am working on a chip/electronic component detection app to detect the offset and rotation of an electronic component which is suspended above the camera and light source on a vacuum needle. The offset and rotation values will then be used to correct the placement of the part.

The needle head and drives can be seen on a video at (needles will be on the left gantry system.)

I am using blob detection to mark the outline of detected components with the code from and I now need to be able to find the centre offset and rotation of the part. I tried the document skew checker but this didn’t seem to return the correct rotation for the blob.

The screen shot below shows the work so far on the app with the chip on the left video feed from the camera and the right side is the processed image


Any recommendations for ways to resolve this or alternative methods are greatly appreciated.

Many thanks

Posts: 1
Joined: Mon Oct 14, 2013 6:16 pm
Location: Swanage, Dorset, UK

Return to Image Processing and Computer Vision